Sunday, July 19, 2015

Install I9300XXUGOF1 4.3 Firmware Update on Galaxy S3 GT-I9300

Firmware update build version I9300XXUGOF1 an Android 4.3 Jellybean for  Galaxy S3 GT-I9300. The I9300XXUGOE1 is a carrier branded firmware and was released in Portugal . The only differences this update has is that it posses a much higher kernel build version but it also got  the same baseband or modem version to the other but also recently rolled out build version I9300XXUGOE1. This update might be very well optimized Android 4.3 or might be some other stuff is along with it. So if you want to give it a try, you may grab the stock firmware below.

Details of I9300XXUGOF1 4.3 Firmware Update:

Device: Galaxy S3

Model number: GT-I9300
Baseband version: I9300XXUGNB1
Kernel version: 3.0.31-2836504
Build number: JSS15J.I9300XXUGOF1

Download I9300XXUGOF1 4.3 Stock Firmware:

Portugal  – I9300XXUGOF1 TPH
Downloads: Galaxy S3 GT-I9300 Stock Firmware

Stock firmware can be use to:

  • Remove root on a rooted Galaxy S3.

  • Return back from modified to official firmware.

  • To repair soft-bricks such bootloops, stuck at welcome screen logo.

  • Manually upgrade if you have missed the OTA update.

How to Install the I9300XXUGOF1 4.3 Update on Galaxy S3 GT-I9300

Odin3_v3.07 Download
GT-I9300 USB Driver Download


  • Make a back-up copy of all important files from the device. You may use any apps for quick back-up.

  • Make sure the battery is fully charge.

Disclaimer: This guide is for advance users only. We shall not be held responsible if anything happens to your device. Proceed at your own risk!

1) Extract or unzip the downloaded firmware or stock ROM so that you’ll get the Odin flashable tar file which is looks likely the same as the image below.
2) Run Odin  v3.10.6 flasher program.
3) Load the binary file. Click on the PDA button then browse to the folder where you extracted the stock ROM. It should look like something like this: “I9300XXUGOF1_I9300OXXGOF1_I9300XXUGNB1_HOME.tar.md5″
4) Do Not check the Re-Partition checkbox. Mark check these checkboxes Auto Reboot and F-Reset Time.
5) Reboot the phone in download mode: To reboot the Galaxy S3 into download mode , you need to turn the power off. After it completely shut down, just press and hold the Volume Down key, Home button and the Power ON/OFF button simultaneously.
You should then prompted into a warning screen and asking you to press volume up if you want to continue or volume down to cancel, just simply press volume up to get into download mode. The download mode then displays an Android robot and say’s “Downloading.. Do not turn off target!!”
6) Connect the phone to PC when it’s in the Download Mode screen.
7) Hit the “START’ button.
8) Wait until a word “PASS’ appears.
9) Remove the phone from PC once completely reboots.

Optional: Perform factory reset to gain a fresher firmware installation, this is very useful to get rid of unwanted reboots and lag issues.

You may then confirm the newly installed Jelly Bean from your device:

You can simply check by going into Settings > About device info and see if it’s already I9300XXUGOF1 4.3 Jelly Bean build.


Post a Comment